Suitable for EP EAN BRO All brands inkj Continuous Ink SupplyR230 R210 IP2780 1510 1000 R330 R1390 T50 R270 IP7280 MP288

Special reminder:
Ink addition has a certain success rate,Not all Ink cartridges must be played out,The situation of this and the ink cartridge itself,The technique of adding ink is related to experience.,If it is added, it cannot be typed or cannot work,It is not within the after-sales scope.

The five ink injection holes of the black ink cartridge are connected, Color fine cartridge red with a hole,Yellow and Blue each have two holes(Experience ink cartridges are all a hole)
Ink adding method for Black Ink Cartridge
1,Put paper towels or Other hygroscopic materials on the table first.,In case of absorbing spilled ink.
2,Gently peel off the label on the ink cartridge(Do not tear up,Still need to post back)Exposed ink injection hole.
3,The five holes arranged under the label are air Guide holes and ink injection holes.,Generally, ink can be injected,But for safety reasons, please find the hole with black ink marks to the light and make sure it is an ink injection hole..
4,Take out the telescopic bottle with black ink,Remove sealing cap,The needle is facing up to drain the air from the bottle as much as possible..Then insert the needle into the ink injection hole,Fill as deep as possible,The ink injection quantity should be controlled in the ink capacity of the ink cartridge1/3Left and Right(4-5MLOK).
5,Hand the ink cartridge(Ink injection hole upward)Placed above the table,Shake the ink cartridge two to three times from top to bottom.To fill the ink cartridge.
6,Wipe the ink cartridge nozzle with tissue,Return label paper sticker.Put the ink cartridge back to the printer2To3Times“Print head cleaning”,Then test and print or nozzle test.
Color fine cartridge ink adding method
1,Remove the label on the top of the ink cartridge,See five small holes under the roll label;
2,Distinguish colors,One hole is red,The two holes are blue,Two holes are yellow(You can insert toothpicks into small holes to distinguish colors.);
3,Put paper towels or other hygroscopic materials on the table first.,In case of absorbing spilled ink.
4,Gently peel off the label on the ink cartridge(Do not tear up,Still need to post back),Exposed ink injection hole.
5,The five holes arranged under the label are air Guide holes and ink injection holes.,Correctly distinguish the three colors of the ink to be injected with the eyelet to the light, so the position(If it is not easy to distinguish, you can use toothpicks.).
6,Take out the blue(Red or yellow)Color ink telescopic bottle,Remove sealing cap,The needle is facing up to drain the air from the bottle as much as possible..Then insert the needle into the ink injection hole of the corresponding color,Fill as deep as possible,The ink injection quantity should be controlled in the ink capacity of the ink cartridge1/3Left and Right(Each color2MLOK).
7,Hand the ink cartridge(Ink injection hole upward)Placed above the table,Shake the ink cartridge two to three times from top to bottom.To fill the ink cartridge.
Special tips:
1,Ink cartridges cannot be filled too much,Black must not exceed10ML Each color cannot exceed4ML,(Experience ink cartridge halved)If it is difficult to master the weight,You can go to the pharmacy to buy a Ink refilling tool,There is a scale on it.Try not to touch the circuit part with ink during ink injection..
2,After ink injection,Stamp the folded facial tissue with a nozzle,If the black ink cartridge is printed with a small black rectangular square,Colored are three thick yellow, red and blue line segments closely attached,Normal,
3,If there is a disconnection in the middle, the color is missing.,Push the nozzle down,Until ink can be produced by the above method!
4,If used3The method is still not good,...,If it doesn't work, I can buy an ink pumping tool for a try.